Maintenance method of plastic shredder

Maintenance method of plastic shredder

In order to ensure the service life of the plastic shredder, under normal circumstances, the plastic shredder will be maintained and cleaned. The following are the daily maintenance and cleaning methods summarized by our Camel Machinery in the practice of selling plastic shredders for a long time.

The plastic shredder is in a bad working environment all year round, so sometimes there will be different degrees of failure. Some failures are not obvious enough, but they are all minor failures and can be easily solved. If the user does not observe carefully, it is difficult to find the existence of these small faults. In the long run, it will inevitably cause serious damage to the shredder, which wastes time, money and energy, and also delays production, efficiency, and output. If abnormal noise is found in the equipment during use, the user needs to check whether the shaft in the inner cavity of the equipment is damaged. If not, it means that there is too little butter on the shaft, which causes the friction between the shaft and the gear to increase, causing abnormal noise. This kind of small fault needs to be discovered and solved in time to avoid major troubles. Users need to add butter to the shaft regularly to prevent damage to the shaft due to poor lubrication.

If the plastic shredder is found to have poor material crushing efficiency during the production process, it should be shut down immediately for inspection. This situation is likely to be caused by the large gap between the cutter heads in the inner cavity of the equipment caused by the long-term crushing of materials with high hardness. This failure is also a normal loss phenomenon. As long as the user checks that the cutter head is not worn, there is no need to replace it, just adjust the gap between the blades.